The configuration card (SX-ISO-CONFIG) must be purchased through Schneider Electric. Once a Security Expert Smart Card Reader is used in an RS-485 configuration it will not work in Wiegand configuration until it has been re-programmed with a configuration card designed for that purpose. Once connecting to the the Smart Reader in RS-485 mode the reader will not communicate if it is then connected up to a Wiegand port. The Smart Card Reader is not able to communicate with the Controller as it is in RS-485 mode but the connection being used is Weigand. Security Expert Smart Card Readers which support both 125Khz and 13.56Mhz (SX-DRD-xx, SX-DRK-xx, SX-RK-xx) The Reader LED is flashing red then green every second continuously. When a card is presented at the Smart Reader it beeps but no card data is sent through to the Security Expert Controller. This can be tested by typing in commands like "ping 127.0.0.1" (IPv4) or "ping ::1" (IPv6). In Wireshark choose this adapter to capture, loopback traffic will be the seen the same way as other non-loopback adapters. Npcap will then create an adapter named Npcap Loopback Adapter. Replace WinPcap with Npcap to emulate a loopback NIC for packet capture. Packets sent between services on the same machine (like SOAP and EWS) do not hit the NIC and therefore cannot be captured with the default configuration of Wireshark using the WinPcap packet sniffing library. When the EWS is installed on the same machine using the service then all packets will be going to the localhost and will not hit the NIC so will not be captured in a Wireshark packet capture.ĮcoStruxure Building Operation, EcoStruxure Security Expertīuilding Operation Automation Servers (AS-P, AS-B)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |